Fortinet Gate 60D - Adding a Policy Route

Policy Route Router Static
FortiGate Version 4.0 Administration Guide
286 01-400-89802-20090424
http://docs.fortinet.com/ • Feedback
Figure 167: Policy Route list
Adding a policy route
To add a policy route, go to Router > Static > Policy Route and select Create New.
Figure 168 shows the New Routing Policy dialog box belonging to a FortiGate unit that
has interfaces named “external” and “internal”. The names of the interfaces on your
FortiGate unit may be different.
Figure 168: New Routing Policy
Create New Add a policy route. See “Adding a policy route” on page 286.
# The ID numbers of configured route policies. These numbers are sequential
unless policies have been moved within the table.
Incoming The interfaces on which packets subjected to route policies are received.
Outgoing The interfaces through which policy routed packets are routed.
Source The IP source addresses and network masks that cause policy routing to occur.
Destination The IP destination addresses and network masks that cause policy routing to
occur.
Delete icon Delete a policy route.
Edit icon Edit a policy route.
Move To icon After selecting this icon, enter the destination position in the window that
appears, and select OK.
For more information, see “Moving a policy route” on page 287.
Edit
Delete
Move To
Protocol To perform policy routing based on the value in the protocol field of the
packet, enter the protocol number to match. The Internet Protocol Number is
found in the IP packet header, and RFC 5237 includes a list of the assigned
protocol numbers. The range is from 0 to 255. A value of 0 disables the
feature.
Incoming Interface Select the name of the interface through which incoming packets subjected to
the policy are received.