Fortinet Gate 60D - Adding and Editing Widgets

Default web portal configurations SSL VPN
FortiGate Version 4.0 Administration Guide
558 01-400-89802-20090424
http://docs.fortinet.com/ • Feedback
Adding and editing widgets
To add or edit SSL VPN web portal widgets, go to VPN > SSL > Portal and select Create
New, then select OK. The SSL VPN web portal is displayed. You can also edit an existing
SSL VPN web portal. You can add, remove, and edit the widgets that appear on the web
portal.
Figure 366: SSL VPN web portal - full-access Default configuration window
Latest Patch Level - If you set Action to Check Latest Version, enter
the latest acceptable patch number.
Tolerance - If you set Action to Check Latest Version, set Tolerance
to 0 if clients must have the latest patch. Set Tolerance to a number to
control how close clients must be to the latest patch. For example, if
the latest patch level is 4 and tolerance is 2, clients will be accepted
with patch 2, 3, 4, 5, or 6.
OK Select to save the configuration. If you select OK, you exit out of the
SSL VPN web portal configuration window.
Cancel Select to exit the configuration window without saving any changes.
Apply Select to apply any changes made in the web portal configuration. If
you select Apply, you will not leave the portal configuration window.
Settings Select to edit the General or Advanced settings for the SSL VPN web
portal. See “SSL VPN web portal” on page 554.
Help Indicates the location of the SSL VPN web portal online help icon. You
cannot change or move this icon. Active when SSL VPN web portal is
activated by user.
Log out Indicates the location of the SSL VPN web portal log out icon. You
cannot change or move this icon. Active when SSL VPN web portal is
activated by user.
Add Widget list Select to add a widget to the SSL VPN web portal configuration.
Help icon
Log out icon
Add Widget list