Default web portal configurations SSL VPN
FortiGate Version 4.0 Administration Guide
564 01-400-89802-20090424
http://docs.fortinet.com/ • Feedback
Tunnel Mode widget
The Tunnel Mode settings display tunnel information and actions in user mode. As an
administrator, you can also configure a split-tunneling option. The presence of this widget
implies that the user group will have tunnel mode enabled. If IP Range is selected, the IP
range of the tunnel must be specified in the user group.
Figure 371: Tunnel Mode widget
Edit Select to edit the information in the Tunnel Mode widget. Opens the
Tunnel Mode configuration window.
Remove widget Select to close the Tunnel Mode widget and remove it from the web
portal home page.
OK Select OK to save the configuration. If you select OK, the Tunnel
Mode configuration window closes.
Cancel Select to exit the Tunnel Mode configuration window without saving
any changes made.
Name Enter a name for the Tunnel Mode widget.
IP Mode Select the mode by which the IP address is assigned to the user.
Range The user IP is allocated from a configured range of IP addresses.
User Group The user IP is assigned on a per-user basis using a RADIUS received
from the RADIUS user group used to authenticate the user. See
“Dynamically assigning VPN client IP addresses from a RADIUS
record” on page 573.
Split tunneling Select to enable split tunneling.
Start IP Enter the starting IP address for the split tunnel range.
To Next Page
Loading...