Web caching WAN optimization and web caching
FortiGate Version 4.0 Administration Guide
616 01-400-89802-20090424
http://docs.fortinet.com/ • Feedback
2 Select Create New and add a Peer Host ID and the IP address for the server side
FortiGate unit.
3 Select OK to save the peer.
4 Go to Firewall > Policy and add a firewall policy that accepts traffic to be web cached.
5 Go to WAN Opt. & Cache > Rule and select Create New.
6 Configure the rule.
7 Select OK to save the rule.
The rule is added to the bottom of the WAN optimization list.
8 If required, move the rule to a different position in the list.
See “Moving a rule to a different position in the rule list” on page 607.
Figure 413: Adding the client side Peer Host ID to the server side peer list
To configure the server side FortiGate unit
1 Go to WAN Opt. & Cache > Peer and enter a Local Host ID for the server FortiGate
unit.
2 Select Create New and add a Peer Host ID and the IP address for the client side
FortiGate unit.
3 Select OK to save the peer.
Peer Host ID Server_Side
IP Address 192.168.30.12
Mode Full Optimization
Source 172.20.120.0
Destination 192.168.10.0
Port 80
Auto-Detect Off
Protocol HTTP
Peer Server_Side
Enable Web Cache Enable
Transparent Mode Enable
Enable Byte Caching Enable
Local Host ID Server_Side
Peer Host ID Client_Side
IP Address 172.20.34.12
To Next Page
Loading...