WAN optimization and web caching Client/server or active passive WAN optimization
FortiGate Version 4.0 Administration Guide
01-400-89802-20090424 619
http://docs.fortinet.com/ • Feedback
4 Select Create New to add the active rule to optimize HTTP traffic for IP addresses
172.20.120.100 to 172.20.120.150.
5 Select OK to save the rule.
6 Select Create New to add the active rule to optimize FTP traffic from IP addresses
172.20.120.151 172.20.120.200.
7 Select OK to save the rule.
8 If required, use the Move To icon to change the order of the rules in the list so that the
HTTP and FTP rules are above the CIFS rule in the list.
See “Moving a rule to a different position in the rule list” on page 607.
Figure 417: HTTP, FTP, and CIFS rules in the rule list
To configure the server side FortiGate unit
1 Go to WAN Opt. & Cache > Peer and enter a Local Host ID for the server side
FortiGate unit.
2 Select Create New and add a Peer Host ID and the IP address for the client side
FortiGate unit.
Mode Full Optimization
Source 172.20.120.[100-150]
Destination 192.168.10.0
Port 80
Auto-Detect Active
Protocol HTTP
Transparent Mode Enable
Enable Byte Caching Enable
Mode Full Optimization
Source 172.20.120.[151-200]
Destination 192.168.10.0
Port 21
Auto-Detect Active
Protocol FTP
Transparent Mode Enable
Enable Byte Caching Enable
Local Host ID Web_servers
Peer Host ID User_net
IP Address 172.30.120.1
To Next Page
Loading...