8
Responses from the Main Panel
When pressing buttons on the Main Panel keypad, you’ll
hear one beep for every button you press. If you don’t hear a
beep, then the panel did not recognize the button press. (It
does not beep when you wake up the keypad.)
When you’ve nished entering a command, you’ll hear two
beeps from the panel to let you know that the command
was recognized successfully.
If a command that you enter was not recognized, you’ll
hear four short beeps instead. You can start over and enter
your command again.
When entering numbers in for a command, such as a Zone
number, the screen will oen display the numbers you’re
currently typing, as well.
• One beep = button pressed
• Two beeps = command recognized
• Four short beeps = command NOT recognized
To Next Page
Loading...
