18
Ring Count
You can change the number of rings that the Main Panel
will wait before answering any inbound phone calls on the
land line. For the purposes of counting, one “ring” is about
6 seconds long.
To change the Ring Count, enter Programming Mode (page
7), then...
12 * [2-digit number] #
For example, to change the Ring Count to 2 rings, the com-
mand would be...
12 * 02 #
e maximum number of rings that can be set is 12.
Line Cut Notification
If the Main Panel detects that a phone line is connected,
but it is not receiving any dial tone on the line, then the
panel will beep 3 times every 30 seconds to notify you.
Without dial tone, the phone control features of the S03
Security System will not work correctly.
You can toggle the Line Cut Notication feature on or o
by entering Programming Mode (page 7), then...
Enable: 22 * 1 #
Disable: 22 * 0 #
To Next Page
Loading...
