15
Using a Secondary RFID Keypad
• Disarm:
Swipe an RFID Key Tag, or enter the Keypad’s pass-
word and then press the Keypad’s Disarm Button.
• Arm:
Enter the Keypad’s password, then press Arm Button.
For more information about the Seconrdary RFID Keypad,
see the Working With Accessories section.
Using the Phone
If you have a land line phone connection, you can also call
the system and control it over the phone. See the Phone
Controls section for more information.
Ready to Arm Feature
e Ready to Arm feature checks to see if any doors or win-
dows are propped open when you try to arm the system. If
there are any open, then the Zone number will be shown.
You can press the Arm button again to override that warn-
ing and arm the system anyway. If the feature is disabled,
then it will not check to see if any doors or windows are
open.
To toggle the Ready to Arm feature on/o, enter Program-
ming Mode (page 7), then...
Enable: 16 * 1 #
Disable: 16 * 0 #
To toggle whether the wired siren chirps with the Ready to
Arm feature, use 68 * 0 # to disable and 68 * 1 # to enable.
To Next Page
Loading...
Need help?
General
