23
Working With Accessories
e S03 main panel can be programmed with up to 100
accessories (150-foot range). e system has 32 numbered
Zones for wireless accessories, which can hold up to 10 ac-
cessories each. It also has support for connecting up to 2
zones of third-party wired sensors. More than one wired
sensor can be on the same zone.
• Remote Key Fobs
• Wireless Sensors / Detectors
• RFID Key Tags
• Secondary RFID Keypad
• Wireless Sirens
• Wired Accessories
• Smart Outlets
• Removing All Accessories
New systems have been pre-programmed by our technicians,
so the accessories should already work with the main panel.
Accessories that you add later will need to be programmed
with the main panel before they will work.
Programming Accessories to the Main Panel
To program an accessory to the main panel, set the panel
into a listening mode, and then trigger the accessory so that
it will send a signal to the main panel to be saved in mem-
ory.
Note: Whenever programming an accessory, you should
make sure that other accessories do not accidentally trigger.
For example, while programming a new door sensor, you
may rst want to turn o any motion detectors that would
pick up your motion.
To Next Page
Loading...
Need help?
General
