37
Performing a Factory Reset
Some rare issues may be resolved by performing a factory
reset in the main panel, then reprogramming the system
and testing again.
To perform a factory reset, enter 0000#.
All programming will be cleared and all settings will be
reverted to the defaults. e default password is 1234.
Checking Placement of Sensors
If one or more sensors is not working consistently or cor-
rectly, or if you are receiving frequent false alarms, you
may need to check the placement of the sensors to make
sure they are oriented correctly for best performance.
• Separate door sensors from metallic door or window frames
with spacers (1/2” or more)
• Door sensors and magnets should be no farther apart than
1/2” when the door or window is closed.
• Motion detectors should not be placed where they can detect
motion from outdoors.
• Smoke alarms should be placed on or near the ceiling.
• Gas leak detectors should be placed on or near the floor.
To Next Page
Loading...
