To install and/or maintain aPower or aGate, please keep the upstream and downstream breakers open and
locked (“lock out”) to prevent misoperation.
If aPower or aGate is found damaged (except minor defects in exterior painting) or malfunctioning after it is
unboxed, please do NOT operate it and contact your after
-sales service provider for support.
Before any debugging operation on aPower, please keep aPower powered off and prevent the ON/OFF switch
from being operated by mistake.
Without the authorization of FranklinWH it is prohibited to take apart, open, repair and/or modify aPower and
aGate. It is prohibited to open the battery pack chamber in whatever situation or otherwise it may lead to safety hazards and
void your warranty.
If aPower is found giving off smoke, please disconnect the AC power supply on aGate, and turn off the switch
mounted on the aPower unit, if possible and safe to stop the charging and discharging of aPower.
Gas exhausted from the battery may lead to risks of electric shock, fire and explosion. Please take appropriate
Measures should be taken to prevent foreign objects from entering aPower and aGate.
For maintenance purposes, do NOT use any parts or fittings that are not listed in this Guide or that are
purchased from any source other than FranklinWH or its recognized dealers.
WARNING: Do NOT use paint on any part of aPower or aGate, whether internal and external, especially on the protective
cover.
Do NOT connect aPower directly to the inverter of the solar generator.
The exterior paint that has been worn out or damaged in the transportation, installation or maintenance
process must be repaired immediately using anti
-rust paint of the same color.
Disconnecting input power from aPower when the temperature falls within the acceptable range (-10°C (-
°F)~ 45°C (113°F)) is acceptable, however the disconnection should last less than one month period.
The operation of the Franklin Home Power system requires an internet connection. Extended offline
operation may result in a voided warranty. Please refer to www.franklinwh.com/Warranty for information.
Safety Instructions for Installation Site
The aPower and aGate installation area of should be protected against access by children and additional
protective measures should be taken to protect the FWH units from being played with or tampered by children.
Sources of heat and fire and heating devices should be kept away from the aPower and aGate installation area.
The ambient temperature at the aPower and aGate installation area should be -20℃ to 50℃(-4℉ to 122℉)
with the relative humidity between 5% and 95% and altitude lower than 3,000 meters (9,843 ft).
DANGER: The aPower and aGate installation area of should be kept in a dry, cool and well ventilated condition, to ensure
satisfactory cooling performance.
The aPower and aGate installation area should be protected from flooding or ponding.
The aPower and aGate installation area should be away from flammable and explosive gases.
The aPower and aGate installation area should be protected from dust or smoke.
APower is heavy. The installation site should be properly leveled and hardened if aPower is floor mounted.
APower is heavy. If the unit is wall-mounted, the wall should be able to provide sufficient bearing capacity.
The aPower and aGate installation area should have no inflammable and/or explosive materials stacked or
piled in the near vicinity.
The aPower and aGate installation area should be protected from direct exposure to sunshine, rain or snow.
WARNING: The aPower and aGate installation area should have no water source over it or in the vicinity, including water
pipes, shower, faucet, and container of liquids.
: Do NOT clean aPower and aGate with cleaning agents or expose them to flammable or corrosive
To Next Page
Loading...
