Step 4: aGate
● Adjust the utility knife until the blade is less than 1 inch long (it may damage aGate if too long). Cut open the adhesive tape on the
upper surface of the aGate carton.
● Open the aGate carton, take out the drill template guide board, accessories, and take aGate out of the box.
WARNING: The blade length must be
less than 1 inch long, or it may damage
the exterior surface of the equipment
stored inside.
● Remove the butter foam from both sides of aGate and remove the PE bag.
WARNING: The drill template guide
board will be used for hole drilling during.
Keep it in good condition before the
installation completes.
Unboxing
● Find a clear, level site of at least 40” x 40” to remove the external and internal panels of aGate.
WARNING: The site needs a protective mat on the ground or the
painting at the back of aGate may be scratched during prep and
unboxing which will affect the anti-corrosion performance.
1000mm
40 in
1000mm
40 in
31
To Next Page
Loading...
