FRANKLINWH APower - Page 72

Commissioning
On the “System parameter” setting page, set up the 2030.5 address.
Redirection
Click on the
position as
shown in the
picture and
input the
2030.5
address. Please
skip this step,
if it is not
required by
local
regulations.
After the
setting is done,
click on
“Complete”.
Click on
“2030.5
resource
address” to
access the
2030.5 address
setting.
Redirection
On the “System parameter” setting page, there are settings in relation to the compliance in case of
parallel operation. Please refer to Appendix 3 and Appendix 4 for FHP BESS and related settings.
Click on “Grid
compliance” to
enter
Compliance
setting page.
Set up the on-
grid
compliance
options on the
“On-Grid
compliance”
page.
71