RWB II PLUS ROTARY SCREW COMPRESSOR UNITS
FORMS
S70-200 IOM
Page 52
START-UP REPORT
Sold To: _____________________________________ Contact Name: _______________________ Date: ________________
End User: ___________________________________ Contact Name: _______________________ Phone: ______________
End User Address: _________________________________________________________________ Fax No: ______________
City, State, Zip: ________________________________________________ Start-up Rep. _____________________________
Unit General Information
Unit Model # _______________________________ Customer Package Identifi cation # _____________________________
Compressor Serial # _________________________ Separator National Board # ___________________________________
Unit Serial # ________________________________ Oil Cooler National Board # ___________________________________
Refrigerant
R-717 R-22 R-290 Other ____________________
Lube Oil Type
2A 3 4 9 Other _______ Design Op er at ing Conditions
Lube System
None Prelube Cycling Full Demand ______ °Suct./ _____ °Disch.
Oil Cooling
TSOC WCOC S-LIOC D-LIOC GCOC
Oil Filters
Single Dual Micro Log I.D. _____________________
Micro Information
Micro Type Quantum Plus Standard Electromechanical U3, U4, U5 Program ____________
SBC / CPU Serial # __________ Rev. ___ U24/U35 Program ID/OS Ver # ____________ and Date _____________
U36 Bios Ver # _______ and Date ___________ U42 Keyboard Ver # _________________ and Date _____________
Digital I/O Board #1 Serial # _____________ Rev. _______ U8 Digital I/O Ver # ____________ and Date _________
Digital I/O Board #2 Serial # _____________ Rev. _______ U8 Digital I/O Ver # ____________ and Date _________
Analog Board #1 Serial # ______________Rev. _____ U13 Analog Ver # _________ and Date ______________
Analog Board #2 Serial # ______________Rev. _____ U13 Analog Ver # _________ and Date ______________
Compressor Motor Information
Manufacturer __________________________________ Frame Size ______________ H.P. ____________ RPM __________
Serial # ___________________________Service Factor ______________ Voltage __________ Hz _______ FLA _________
Design ____________Code ______________ Bearing Type
Antifriction Sleeve
Compressor Motor Starter Information
Manufacturer ___________________________ Serial # ____________________________
Starter Type WDCT ATL Auto-Trans Solid State Digital DBS Standalone DBS
CT Location Checked
CT Phase ______ CT Ratio ________ Transition Time ___________ DBS Ver. # ____________
Oil Pump Information
Pump Manufacturer __________________ Model # ____________________ Serial # _________________________
Motor Manufacturer __________________ H.P. __________ RPM ________ Serial # _________________________
Service Factor ______ Voltage ________ Hz __________ FLA ________ Design ______ Code _____ Starter Size ________
Special Options
DX Economizer Frick Supplied Starter PC Control System Other
Prestart Checks
Position of all valves All wiring connections Motor rotation Oil pump motor rotation
All micro settings Cold alignment Proper oil charge Installation, Foundation
Factory Setup Options (Quantum™)
No Pump Prelube Cycling Full Time Dual Oil Filter Transducer Yes No
Refrigerant ___________ K-Factor for User Defi ned Refrigerant ________ Slide Valve Travel _____________
Dual Dischaarge Control
Enabled Disabled Liquid Injection Cooling Enabled Disabled
Main Oil Injection Control
Enabled Disabled Balance Piston Setup Enabled Disabled
Oil Log Setup
Enabled Disabled Enable Aux 1 & 2 None 1 2 Both
To Next Page
Loading...
