Friedrich Kuhl+ KEQ08A11A User Manual

35 PB
OPERATION
Heating Fan Delay
ThisisonlyforfanModeAuto(Fancycleswithcool/heatoperation)andnotforcontinuousfanmode.Whenunit
cyclesHeatingON–startsthefan5secondsEARLY.WhenunitcyclesHeatingOFF–DELAYSthefanofffor15
seconds.
Fan Speed Change Delay
Relayactivationisdelayedbyaminimumnumberofseconds.Thedefaultforthisvalueis2secondsandisusedto
eliminaterelaychatter.
System Mode Fan Only
Thefanisturnedonandrunsatthespeciedmanuallysetspeed.
OnlytheFanisturnedon.CoolorHeatoperationareoff.
(ThisisdifferentthanFANMODEONwherethefanisonwiththecoolorheatoperation).
Fan Only Rules
1. IftheSYSTEMFANONLYMODEisselected,theAutofanmodeisdisabled,andthefanmodeisforcedto
continuous.Inaddition,theautofanspeedisdisabled.Iftheuserpressesthefanspeedkey,themenuwillskip
overtheautoselection.Thesetpointtemperaturedisplayisoff.
2. AnyfanspeedmaybemanuallyselectedduringFanOnlyMode.
Fan Operation (Front Panel Mode)
Heat – Cool – Auto – Fan Only
AllModelshave3speeds.
Fan ICON Detail
TheFanSpeedICONwillDisplayasLOW,MED,orHIdependingonwhichspeedisselected.

Friedrich Kuhl+ KEQ08A11A Specifications

General

Brand	Friedrich
Model	Kuhl+ KEQ08A11A
Category	Air Conditioner
Language	English