Fronius MHP 280i G CMT - Start-up; Fitting Wearing Parts to the Torch Body; Inner Liner Note for Gas-Cooled Torches

Start-up
MTG d, MTW d -
Fitting wearing
parts to the
torch body
1 2
3
** Screw on and tighten the gas
nozzle as far as it will go
Note regarding
the inner liner
with gas-cooled
welding torches
NOTE!
If a plastic inner liner is used in the torch body of a gas-cooled welding torch,
reduce the power figure shown in the technical data by 30%.
▶
To operate gas-cooled welding torches at maximum power, use a steel inner
liner in the torch body.
46