Wall Mounting
NOTE! The IP 54 protection class only applies if the cover is rmly screwed to
the back.
IMPORTANT! Depending on the surface, different types of xings are required for
mounting the Ohmpilot. The xings are therefore not included in the scope of supply for
the Ohmpilot. The tter is personally responsible for selecting the correct xings. The
Ohmpilot must be mounted with four screws. Ensure that the screws are tight and that
the wall is stable. .
To install the Ohmpilot, the manufacturer recommends the use of steel screws with a
diameter of 4 - 6 mm.
Safety
Selecting Wall
Plugs and
Screws
Recommended
Screws
Installation
Instructions
CAUTION! Risk of damage to the Ohmpilot due to dirt or water on the termi-
nals and in the electronics. When drilling, ensure that the terminals and elec-
tronics do not become dirty or wet.
1 2
3 4
max. 3Nm
To Next Page
Loading...
