Fronius Ohmpilot - Status Indication on Web Interface

42
OK
TARGET
TEMPERATURE
LEGIONELLA PRE-
VENTION
BOOST
ERROR
Ohmpilot is operating in normal mode.
Temperature has fallen below the minimum. Heater 1 is heating at 100%.
Legionella heating is active. Heater 1 is heating at 100%.
The Ohmpilot has been switched to boost mode manually. Heater 1 is
heating at 100%.
An error has been detected. More information should be read off from
Solar Web.
Current measured temperature. A valid value is only displayed when a
temperature sensor is connected.
Current power being used by the Ohmpilot.
Heater 2 is active. Heater 2 may be a second heating element, a heat
pump or an external source (e.g. gas-red heating).
Phase 2 of 3-phase heating element is active.
Phase 3 of 3-phase heating element is active.
Status Indication on Web Interface
Status
Temperature
Heat output
Heater 2
L2 heating element
L3 heating element