Fronius Ohmpilot - Fronius Smart Meter; Integrating the Fronius Smart Meter

16
How to connect the Fronius Smart Meter to the Fronius Datamanager 2.0:
Fronius Smart Meter
A Fronius Smart Meter is required for operation of the Ohmpilot, so that the surplus
energy can be measured. For integration of the Fronius Smart Meter, an inverter with
Datamanager 2.0 and software version V3.8.1-x or higher and/or a Datamanager Box
(from software version 3.8.1-x) is necessary. It must be congured on the Datamanager
whether the Fronius Smart Meter is installed at the feed-in point or in the consumption
branch. The setting must be implemented on the webpage under the "Meter" tab for the
Datamanager.
Further information on the Datamanager can be found in the "Fronius Datamanager 2.0"
Operating Instructions
(1a) Meter position at feed-in point
The power and energy fed in are measured. Consumption is determined based on
these values and the system data.
(1b) Meter position in consumption branch
The power and energy consumed are measured directly. The power and energy
fed in are determined based on these values and the system data.
Integrating the
Fronius Smart
Meter
(1a)
(1a)
(1b)
(1)
(1b)
Fronius Smart Meter
INPUT
L1
L2
L3
N
OUTPUT
RS 485
DT/PE
Rx / x GND
1
A B C D
3 4 6 7 9 11
LOAD
XXX
X
X
X
+
T
-
Fronius
Datamanager
2.0
120 Ω
ON
- D+ D-