Fronius Ohmpilot - Menu Settings for External Source Operation

30
1. The section "Establishing the Data Connection" describes how you can access the
Ohmpilot website.
2. Highlight the eld "Temperature sensor present"
3. Highlight the eld "Adapt day curve"
4. Under "Time from", enter the time from which the minimum temperature should be
adjusted, and the specic minimum temperature.
5. Under "Target temperature", enter the required temperature.
6. Under HEATER 2, select "Activate external source"
Example 1:
If you enter 6.00 am under "Time from" and select 45 °C as the temperature, the heat-
ing will operate from 6.00 am until such time as a temperature of 45 °C is reached. The
external source (e.g. gas-red heating) will only be activated if the temperature is below
the set value.