Fronius Ohmpilot - Appendix

49
EN
Electronic RS 2.5.5 independently mounted RS
2.10.6.1 mounting method type Y
Protection class I 6.8.3
Micro interruption according to 2.4.4.
PTI 175 according 6.13.2
N according to 7.4.3, earth connection according to
9.1.1
Mode of operation TYPE 1 according to 2.6.1
C according to 6.4.3.3
Casing 550°C, the cable bushing / strain relief 650°C;
Category B according to EN 60730-1:2000/A1:2004;
According to EN 61000-6-2:2005, EN 60730-1:2011,
EN 301 489-1 (V1.9.2)
Wire to wire | Cable(s) to earth
Signal and control wires: --- ± | 1 kV
DC power inputs: ± 0.5 kV | ± 0.5 kV
AC power inputs: ± 1 kV |± 2 kV
According to 21.2.1, 21.2.2, 21.2.3 and 21.2.4,
Casing:
Ball pressure test 1: 102 °C
Cable bushing:
Ball pressure test 2: 125 °C
max. 3Nm
According to EN 61000-6-2:2005, EN 60730-1:2011,
EN 301 489-1 (V1.9.2)
Wire to wire | cable(s) to earth
Signal and control wires: --- ± | 1 kV
DC power inputs: ± 0.5 kV | ± 0.5 kV
AC power inputs: ± 1 kV |± 2 kV
Inspection / Specications
Inspection / Specications according to EN60730 Section 1 Table 7.2
6a
19
24
29
30
31a
39
40
51
75
77
78
80
Construction
Screwless Terminal
RS Classication, to Protect Against
Electric Shock Section 6.8
Type of Disconnection or Interruption
for Each Circuit
PTI-Value of the Insulation Material
Used for Insulation
Protective Earth Connection Type
Mode of Operation
Additional Features of Mode of
Operation
Heat Filament Test Temperatures (Sec-
tions 21.2.1, 21.2.2, 21.2.3 and 21.2.4)
Rated Impulse Voltage (Section 2.1.12,
20.1)
Ball Pressure Test Temperature
Maximum Specied Torque for
Single-Bush Mounting with a Thermo-
plastic Material (Table 20, Note 1)
Rated Impulse Voltage for Creepage
and Clearance Distances