Fronius Primo 5.0-1 AUS - Inverter Setup and Configuration; Initial Configuration and Adjustments; Navigating the Setup Menu

SETUP menu item
Initial setting The inverter is pre-configured after commissioning has been completely carried
out (e.g. using the Installation Wizard) according to the country setup.
The SETUP menu item allows the initial settings of the inverter to be changed
easily to bring it in line, as closely as possible, with the preferences and require-
ments of the user.
SETUP
GRAPH
SETUP
(Setup menu)
NOTE!
As a result of software updates, you may find that your device has certain func-
tions that are not described in these Operating Instructions, or vice versa.
Certain illustrations may also differ slightly from the actual controls on your
device, but these controls function in exactly the same way.
Navigating the
SETUP menu
item
Entering the SETUP menu item
GRAPH
Menu level, "SETUP" selected
1
At the menu level, use the "Left" or
"Right" keys to select the "SETUP"
menu item
2
Press the "Enter" key
Relay
"Standby" entry
The first entry under the SETUP menu item
is displayed:
"Standby"
Scrolling between the entries
25
EN