Fronius Primo 5.0-1 AUS - Modifying Menu Settings

Relay
Example: "WiFi Access Point" menu item
3
Use the "Up" and "Down" keys to
scroll between the available entries
Exiting an entry
GRAPH
4
To exit a menu entry, press the "Back"
key
The menu level appears
If no key is pressed for 2 minutes:
-
The inverter switches from wherever it is on the menu level back to the
"NOW" display mode (exception: "Standby" Setup menu entry),
-
The display backlighting goes out.
-
The amount of power currently being fed in is displayed.
Setting menu
entries, general
1
Open the desired menu
2
Use the 'Up' or 'Down' keys to select the desired menu item
3
Press "Enter"
The available settings are displayed: The first digit of a value to be set
flashes:
4
Use the 'Up' or 'Down' buttons to
select the desired setting
5
Press the 'Enter' key to save and
apply the setting.
To discard the setting, press the
'Esc' key.
4
Use the 'Up' or 'Down' keys to se-
lect a value for the first digit
5
Press "Enter"
The second digit of the value flashes.
6
Repeat steps 4 and 5 until ...
the whole value to be set flashes.
7
Press "Enter"
8
Repeat steps 4 - 6 as required for
units or other values that are to
be set until the appropriate unit
or the value flashes.
9
Press the 'Enter' key to save and
apply the changes.
To discard the changes, press the
'Esc' key.
26