Fronius Robacta Reamer V Twin - Scope of Supply; Available Options; How the Wire Cutter Works;Maximum Wire Diameter

Scope of supply
(1)
(2)
(3)
(4)
NOTE!
The "Robacta Reamer" parting agent
(item number 42,0411,8042) and the
cleaning cutter are not part of the
scope of supply.
(1) Robacta Reamer V Twin clean-
ing device with wire cutter
(2) Spatter tray
(3) Tightening key for cleaning mo-
tor
(4) Compressed air relief valve
not shown:
(5) Standard I/O connecting plug (X1) without cable
(6) Operating instructions
(7) Fixings for assembling the cleaning device:
-
4 screws
-
4 washers
-
4 lock washers
-
4 nuts
Available op-
tions
The following options are available for the cleaning device:
-
Installation stand
-
Cleaning cutter adjustment aid
-
Level sensor
How the wire
cutter works/
Maximum wire
diameter
The wire cutter opens and closes when there is an active signal from the robot
control.
Two wire electrodes with a diameter of up to 1.6 mm (0.063 in.) can be cut at the
same time by the cleaning device wire cutter.
NOTE!
If you change over to a new welding torch, the wire cutter must be reset!
16