The device must be incorporated into a higher-level safety system within a se-
cured area.
If this area has to be accessed when setup and maintenance work is carried out,
make sure that
-
the entire system is switched off for the duration of the work in this area
-
and that it is prevented from starting up accidentally, e.g. as the result of a
control fault.
If untrained operators have access to the device, its compressed air supply must
be disconnected for the duration of work in accordance with "Performance Level
d" of the ISO 13849-1 standard.
In addition to these Operating Instructions, the safety rules issued by the robot
manufacturer must also be observed.
Keep your body, especially your hands, face, hair, clothing and all tools away from
moving parts, such as:
-
rotating cleaning cutter
-
upwards/downwards travelling cleaning motor
-
extending/retracting gas nozzle clamping device
-
wire cutter
Do not touch cleaning cutters immediately after use - risk of burns. Observe the
special safety rules in the Operating Instructions for handling cleaning cutters.
Protect hands, face and eyes against flying parts (shavings, etc.) and compressed
air/parting agent mixture escaping from the parting-agent injection nozzle.
Covers may only be opened/removed for the duration of any maintenance, in-
stallation or repair work.
During operation
-
Ensure that all covers are closed and fitted properly
-
Keep all covers closed
Protecting your-
self and others
Anyone working with the device exposes themselves to numerous risks. In addi-
tion to these Operating Instructions, the safety rules of the manufacturer of the
entire welding system must also be observed.
Keep all persons, especially children, out of the working area while any devices
are in operation or welding is in progress. If, however, there are people in the vi-
cinity:
-
Make them aware of all the dangers and health risks (crushing from mechan-
ically-powered parts, injury from cleaning cutter, flying shavings and similar
matter, escaping compressed air/parting agent mixture, flying sparks,
dazzling by arc, inhaling of harmful welding fumes, noise, possible danger
from mains or welding current, etc.)
-
Provide suitable protective equipment
-
Alternatively, erect suitable safety screens/curtains
EMC Device
Classifications
Devices in emission class A:
-
Are only designed for use in industrial settings
-
Can cause line-bound and radiated interference in other areas
Devices in emission class B:
-
Satisfy the emissions criteria for residential and industrial areas. This is also
true for residential areas in which the energy is supplied from the public low-
voltage mains.
8
To Next Page
Loading...
Need help?
General
