Fronius Robacta Reamer V Twin - Fitting the Fill-Level Control Sensor

Fitting the fill-
level control
sensor
(3)
(1)
(2)
(1)
(2)
1
2
1
NOTE!
First press the upper part of the
sensor into the installation adapter as
shown - the sockets (1) on the installa-
tion adapter must fit into the recesses
(2) in the sensor.
When the upper part of the sensor is
properly lined up in the installation ad-
apter, press the sensor fully into the
installation adapter - the latch (3) on
the installation adapter must snap
back over the sensor (sensor audibly
engages).
**
1
2
2
* Use the fixings supplied with
the sensor.
****
1
1
1
1
3
Screw the installation adapter and
sensor on to the parting agent contain-
er housing
** Fixings are not included in the
sensor/installation adapter
scope of supply. The installer is
responsible for selecting the
right type of fixing.
NOTE!
Ensure the fixings do not damage the
parting agent container.
48