Fronius Robacta Reamer V Twin - Page 42

(3)
(2)(4)
(5)
0,5-1mm
.02-.04in.
4
Loosen the Allen screw (2) on the
lifting device
5
Push the lifting device (3) by hand
into its highest lift position and
hold in place
6
Push the cleaning motor (4) and
cleaning cutter by hand into the
cleaning position (5)
NOTE!
The cleaning cutter must not touch
any welding torch components.
7
Fix the cleaning motor (4) in this
position in the lifting device (3) -
tighten the Allen screw (2) on the
lifting device
1
2
2
8
42