Fronius SYMO Series Service Manual & Spare Parts List

69
EN-US
Tools and measurement devices
General The "Tools and measurement devices" chapter contains an overview and a description of
all the tools needed to properly service the device. This includes the following tools:
- Required tools
- Measuring and inspection equipment
- Auxiliary materials
Tools required - Torx screwdriver, TX20
- Torx screwdriver, TX25
- Slotted screwdriver, 3 mm
- Socket wrench
- Socket wrench insert, 7 mm
- Socket wrench insert, 36 mm
- Flat wrench, 7 mm
- Flat wrench, 36 mm
- Diagonal cutting pliers
- Needle-nosed pliers
- Torque screwdriver with bit insert, 1 - 6 Nm
- Torque ratchet, 1 - 10 Nm
- Allen key, 4 mm
- Allen key, 5 mm
Measuring and In-
spection Equip-
ment
- Digital multimeter
- Equipment for safety inspection
Auxiliary Materi-
als
- Cleaning material (spray, paper)
- Cable ties 102 and 200
- Heat conducting film TPC (42,0300,3054)
- Screw with gasket PT 5x25 (42,0401,4231)

Fronius SYMO Series Specifications

General

MPPT Number	2
Frequency Range	50 / 60 Hz
Operating Temperature Range	-25°C to +60°C
Communication	WiFi, Ethernet, RS485
AC Nominal Voltage	3 x 230 V / 400 V
Output Voltage	3 x 230 V / 400 V
Warranty	5 years