Fronius TransPocket 5000 CEL - Page 95

.4.3.2.1
TIG Comfort Stop
1
Welding
2
Raise the welding torch: the arc length is increased significantly
3
Lower the welding torch:
-
The arc length is decreased significantly
-
The TIG Comfort Stop function is triggered
4
Keep the welding torch at the same height
-
The welding current is continuously decreased (downslope)
-
Arc goes out
5
Wait for the gas post-flow time to finish and lift the welding torch off the
workpiece
I
t
(1) (3)
(4)
(2)
TIG welding process with the optional TIG Comfort Stop function activated
(1) Gas pre-flow
(2) Set welding current
(3) DownSlope
(4) Gas post-flow
95
EN