Fronius TransPocket 5000 CEL - MMA Welding; Parameters; TIG Welding

Parameters
MMA welding The HCU (HotStart current) function and available setting range are described in
the section headed "MMA welding".
HCU
HotStart current
Unit m/min
Setting range 0 - 100%
Factory setting 50%
Hti
Hot-current time
Unit s
Setting range 0 - 2.0 s
Factory setting 0.5 s
FAC
Factory - reset power source
Press and hold the Setup / Store button (7) for 2 s to reset the device to its
original (i.e. factory) settings. If the display reads "PrG", then the power source
has been reset
IMPORTANT! When the power source is reset, all personal settings in the Le-
vel 1 Setup menu are lost.
The functions in the second level of the Setup menu (2nd) are also deleted.
2nd
Second level of the Setup menu (see section "Setup menu: level 2")
TIG welding
2nd
Second level of the Setup menu (see section "Setup menu: level 2")
97
EN