Fronius TransSteel 4000 Pulse User Manual

10000 to 99999 / 10.0 to 99.9
(without unit or tens digit, e.g., 23580 kJ -> 23.6)
Ejt EasyJob Trigger
To activate/deactivate switching between EasyJobs using the torch trigger
Unit: -
Setting range: On/OFF
Factory setting: OFF
Function with MIG/MAG torch trigger
Press torch trigger briefly (< 0.5 s)
No welding taking place:
-
Toggles through all MIG/MAG EasyJobs in sequence.
-
If an EasyJob is not selected, the torch trigger functions normally.
-
If a MIG/MAG EasyJob is not selected, no change is made.
Welding taking place:
-
Toggles through MIG/MAG EasyJobs with the same operating mode
(4-step, special 4-step, 4-step stitch welding) and with the same weld-
ing process.
-
It is not possible to switch during spot welding.
Function with MIG/MAG Up/Down key
If an EasyJob is selected, the EasyJob is changed, otherwise the welding
current is changed.
No welding taking place:
-
Toggles through all MIG/MAG EasyJobs in sequence.
Welding taking place:
-
Toggles through MIG/MAG EasyJobs with the same operating mode
(2-step, 4-step, special 4-step, 4-step stitch welding) and with the
same welding process.
Switching back is possible.
Parameters for
manual metal
arc welding in
Setup menu 2nd
level
SEt Country-specific setting (Standard/USA) ... Hour/US
Unit:
Setting range: Std, US (Standard/USA)
Factory setting:
Standard version: Std (dimensions: cm / mm)
USA version: US (dimensions: in.)
r r (resistance) - welding circuit resistance (in mOhm)
See the section "Measuring the welding circuit resistance r" from page
106.
L L (inductivity) - welding circuit inductivity (in microhenrys)
See the section "Displaying the welding circuit inductivity L" from page
108.
105
EN-US

Fronius TransSteel 4000 Pulse Specifications

General

Brand	Fronius
Model	TransSteel 4000 Pulse
Category	Welding System
Language	English