35
EN-US
Safety inspection
Safety inspection This chapter describes the safety inspection for the device described in these Service In-
structions. The safety inspection instructions have been prepared in accordance with the
IEC 60974-4 standard. Excerpts of the required measurement methods are documented
in Fronius treatment specification PMÜ-01.
Please observe the requirements and standards for your particular country, since there
may be deviations in the measured values or inspection steps.
If there are no requirements and standards for your particular country, Fronius recom-
mends that this inspection is still carried out.
The safety inspection must only be conducted on a completely assembled device.
Responsibility The repairs technician is responsible for the proper performance and documentation of the
safety inspection, and for the correct inspection result. Fronius accepts no liability.
If a defect is identified during the inspection, the safety inspection must be repeated once
the defect has been eliminated.
The following inspection steps must be carried out in the sequence specified. Every in-
spection must be passed before the next inspection can begin. If one of the inspections
cannot be carried out, the inspector must take the decision, and the responsibility and lia-
bility falls to him regarding whether the safety of the device can still be confirmed. This de-
cision must be justified accordingly and included in the inspection log under Notes.
To Next Page
Loading...
Need help?
General
