71
EN-US
In the event of an error:
- Inspect torch hosepack, welding torch, and grounding cable for damage
- Check connections and contacts
- Check the cleanliness of the workpiece surface
Slope Time 1 (only available in 4-step mode)
Ramping time from the main current I
1
to the lowering current I
2
off / 0.01 - 9.9 s
Factory setting: 0.5 s
Slope Time 2 (only available in 4-step mode)
Ramping time from the lowering current I
2
back up to the main current I
1
off / 0.01 - 9.9 s
Factory setting: 0.5 s
Trigger
Torch trigger operating mode
off / on
Factory setting: on
off
Operating welding torch without torch trigger
High frequency ignition is deactivated.
on
TIG 2-step or 4-step mode
HF ignition
off / on
Factory setting: on
off
No HF ignition at the start of welding - welding started by contact ignition
on
HF ignition is activated
The HF ignition special indicator illuminates on the control panel when the "HF
ignition" parameter is set to "on".
To Next Page
Loading...
Need help?
General
