STORAGE
END OF SEASON
1. Clean rake thoroughly. Trash and dirt will draw
moisture and cause rust.
2. Put rake in a dry place.
3. Thoroughly lubricate machine. (See Lubrication and
Maintenance section.)
4. Apply a thin layer of grease on exposed cylinder
rods to prevent rusting.
5. Check hydraulic hoses for deterioration and replace
if necessary.
6. Tighten any loose bolts, nuts, and hydraulic fittings.
7. Repair or replace worn or broken parts.
8. Paint all parts where necessary.
9. Replace damaged or missing decals.
10. List replacement parts needed and order them
early.
BEGINNING OF SEASON
1. Review operator’s manual and check adjustments.
2. Lubricate complete machine. (See Lubrication and
Maintenance section.)
3. Check air pressure in tires. Correct tire pressure is
350 kPa (50 psi ) (3.2 Bar).
4. Check all hardware for tightness.
5. If any major moving parts have been replaced,
make sure they run properly.
45
To Next Page
Loading...
