1-1
Chapter 1 BEFORE USING THE INVERTER
1.1 Acceptance Inspection
Unpack the package and check that:
(1) An inverter and instruction manual (this manual) is contained in the package.
(2) The inverter has not been damaged during transportation—there should be no dents or parts
missing.
(3) The inverter is the model you ordered. You can check the model name and specifications on the
main nameplate. (Main and sub nameplates are attached to the inverter and are located as
shown on the following page.)
(a) Main Nameplate (b) Sub Nameplate
Figure 1.1 Nameplates
TYPE: Type of inverter
Note: When "None" and "w/o braking resistor (standard)" are selected in the built-in option and brake in the
above codes, respectively, the type of inverter is written without the last 2 digits as a standard model.
SOURCE: Number of input phases (three-phase: 3PH, single-phase: 1PH), input voltage, input
frequency, input current
OUTPUT: Number of output phases, rated output capacity, rated output voltage, output
frequency range, rated output current, overload capacity
SER. No.: Product number
7
1 A 1 2 3 A 0 0 0 1 Z
Serial number of production lot
Production month
1 to 9: January to September
X, Y, or Z: October, November, or December
Production year: Last digit of year
If you suspect the product is not working properly or if you have any questions about your product,
contact your Fuji Electric representative.
To Next Page
Loading...
