1-2
1.2 External View and Terminal Blocks
(1) External views
Figure 1.2 External Views of FRENIC-Mini
(2) View of terminals
(a) FRN0.75C1S-2 (b) FRN1.5C1S-2
(* When connecting the RS-485 communications cable, remove the control
circuit terminal block cover and cut off the barrier provided in it using nippers.)
Note: A box () in the above model names replaces A, C, E, or J depending
on the shipping destination.
Figure 1.3 Bottom View of FRENIC-Mini
1.3 Transportation
• When carrying the inverter, always support its bottom at the front and rear sides with both hands.
Do not hold covers or individual parts only. You may drop the inverter or break it.
• Avoid applying excessively strong force to the terminal block covers as they are made of plastic
and are easily broken.
Barrier for the RS-485
communications port*
Control signal cable port
Cooling
fan
L1/R, L2/S, L3/T, P1, P (+), N (-)
wire port
L1/R, L2/S, L3/T, U, V, W,
grounding wire port
DB, U, V, W,
grounding wire por
Heat
sink
DB, P1, P (+) and N (-) wire port
Keypad
Main
nameplate
Control circuit
terminal bock cover
Control circuit
terminal block
cover
Main circuit
terminal block
cover
Sub
nameplate
Main
nameplate
To Next Page
Loading...
