3-3
*1 In speed monitor, you can have any of the following displayed according to the setting of function code
E48: Output Frequency (Hz), Reference Frequency (Hz), Load Shaft Speed (r/min), Line Speed (m/min),
and Constant Rate of Feeding Time (min)
*2 Applicable only when PID control is employed.
*3 Applicable only when timer operation is selected by the setting of function code C21.
*4 Applicable only when a remote keypad (optional) is installed.
*5 Alarm can be reset with the
key only when the current alarm code is displayed.
Figure 3.2 Transition between Basic Display Figures by Operation Mode
To Next Page
Loading...
