5-17
V/f pattern with single non-linear point inside the base frequency
You can also set the optional non-linear V/f range (H50: Frequency) fo
frequencies exceeding the base frequency (F40).
F07
F08
Acceleration Time 1, Deceleration Time 1
The acceleration time specifies the length of time the frequency increases from 0 Hz
to the maximum frequency. The deceleration time specifies the length of time the
frequency decreases from the maximum frequency down to 0 Hz.
In case the reference frequency is equal to the maximum frequency (F03)
The actual acceleration and deceleration times are the same as the specified ac-
celeration time and deceleration time.
To Next Page
Loading...
