1.4.4. Configuring Loader
If Loader starts, the Quick Access Menu first appears as shown below.
This menu contains the 7 quick-start icons for the programs contained in Loader. To start a
program, simply click the corresponding icon.
Details of the programs are described in Chapter 2.
When using Loader for the first time or after having changed the supporting inverter(s), you need
to configure the operating environment by setting up the communications parameters (COM
Setting).
Click the COM Setting icon to open the Communication Setting dialog or Device connection
list window.
Configures
communi
cations
parameters
If the Quick Access Menu is not displayed, click the icon on the toolbar (shown
below) at the bottom of the Loader top window to open the menu.
36
To Next Page
Loading...
