Fuji Electric Frenic User Manual

[ 3 ] For connection to Communication board (Ethernet)
When " Communication board (Ethernet)" is selected
Only a single line appears as shown below. After making sure that the equipment name and
RS-485 num. (station address) are correct, click the Browse button to monitor the current
communications link status.
Browse
Clicking this button checks
whether a link between
Loader and the inverter is
established. The result
appears in the Status column.
Status column
- Unknown : The communications status has been unknown.
- Connecting : The communications link has been established.
- Disconnected : The communications link has not yet been established.
Advance…
Clicking the row to be modified and clicking
this Advance button calls up the Advanced
dialog shown at the right.
Clicking the OK button returns to the Device
connection list window.
After completion of data entry, check the settings again and click OK to exit the device
connection operation.
42

Fuji Electric Frenic Specifications

General

Series	Frenic
Overload Capacity	150% for 60 seconds
Communication Options	RS485
Protection Functions	Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit
Enclosure	IP20
Cooling Method	Fan Cooled
Operating Temperature	-10°C to 50°C
Storage Temperature	-20°C to 65°C
Ambient Humidity	5% to 95% (non-condensing)
Altitude	Up to 1000m
Output Voltage	3-phase 230V, 3-phase 480V, 3-phase 600V, 3-phase 690V