[ 2 ] Adjust graph position
Each box in the cursor sub window shows the channel setting values or status at each cursor
position.
You can use the boxes to adjust the graph position at each channel.
Select CH
Select the channel at which the graph position is
adjusted.
Display
Display only the channels with checked mark.
Hide the channels without checked mark.
Y axis display position
Set the Y axis display position of the selected
channel. The upper end comes to 0 point (50 points
each at grid).
X axis display position
Set the X axis display position of the selected
channel. The leftmost end comes to 0 point (200
points each at grid).
Amplitude
Set the amplitude of the selected channel by magnification (in increments of 0.25).
Change the magnification using 0 point for reference.
As changing the amplitude input value, Scale/DIV value changes in unison and the graph
display also changes according to the Scale/DIV value.
Scale
Set the scale of the selected channel.
Enter the numeric value per DIV. This setting covers the analog setting channels only.
Graph position reset
Reset the display position and amplitude setting of the selected channel to the initial values.
・Y axis display position: Ch1 = 50 and the value increments by +50 for the subsequent
channels.
・X axis display position: Each Ch = 0
・Amplitude: 1.00
78
To Next Page
Loading...
