App.2-2
Appendix 2 Automatic Update of System Software
<Update procedure>
On the loader screen, display the “Control” dialog.
If the monitor mode is selected, set it off.
a) For SX-programmer Expert (D300win)
While an SPF project is open, click the [Online] menu > [Project Control].
b) For SX-Programmer Standard
While an SPF project is open, click the [Online] menu > [PLC Operation (Run/Stop, Load)].
*When the system software version of the SPF matches that of the loader, the “Control” dialog box opens.
If the system software version of the SPF is older than that of the loader, the following dialog box appears.
Click the “Yes” button to display the following dialog box. After conrming that the monitor mode is off, click the “OK” button.
The system software utility starts up.
Notes:
To start up the system software utility, be sure to close the other application programs.
To Next Page
Loading...
