Fuji Electric MICREX-SX series - Page 86

App.1-10
Appendix 1 Offset/Gain Adjustment <D300win>
Appendix 1-2 Offset/Gain Adjustment of Analog Output Module
7) After the completion of gain adjustment, set ON bit 0 (zero) of the parameter setting data register (offset address +6) to write
the gain adjustment value in the module internal EEPROM. Confirm the completion of EEPROM writing, in the same way as
explained for offset adjustment.
Completion of EEPROM writing
EEPROM write command
8) Set OFF all the bits of the parameter type setting register, and clear all the bits of the parameter setting data register to zero.
This completes the adjustment work.
Clear all these to zero.
Finally clear the mode
changeover register
(offset address +4) to zero.