Figure 79: MSG Instruction Selection
b) Select the “XIO” instruction from the “Bit” classification, then click OK. Refer to Figure 80.
Figure 80: XIO Instruction Selection
5) Configure the MSG instruction.
a) Set the “Read/Write” field to “Read”, “Target Device” field to “PLC5”, “Local/Remote” field to
“Loc al”, and “Control Block” to “N20:0”.
b) Upon hitting the <ENTER> key while in the “Control Block” entry box, the MSG Properties
dialog box should appear (or it can be opened by clicking on the “Setup Screen” button at the
bottom of the MSG instruction). Refer to Figure 81.
To Next Page
Loading...