Fuji Electric RYS201S3-VVS - Dynamic Braking; Major Fault; Minor Fault

MHT258a (Engl.)5-54
5.7.9 Dynamic braking
This signal is output when the amplifier detects major fault.
This signal is turned on when such a major fault has occurred that the amplifier cannot drive the motor, and is retained until alarm reset
signal is input.
Dynamic braking is a braking type to short-circuit the coils between three phases of a synchronous motor to generate power.
Once the motor is stopped, braking force is not retained.
The output terminal of dynamic braking is +30V DC, 50mA. This cannot directly close a magnetic contactor. Use a general purpose relay or
FUJI SSC (solid state contactor).
■ Interface
■ Parameter setting
To allocate the dynamic braking signal to the control output terminal, set (15) to the system para.
■ Related items
・Major fault
Fault that cannot drive motor
Dynamic braking (15)
ON : Major fault is detected
OFF : In normal operation
・
Minor fault
Protection against overheat etc.
+24V
Indication Detection contents
Overload
Overspeed
Overvoltage
Encoder error
Encoder communication error
Control power error
Memory error
Undervoltage
Overcurrent
Combination error
Resistor heat 2
CONT signal error
System error
Indication Detection contents
Resistor overheat
Deviation over
Amplifier overheat
Encoder overheat
ABS data lost
Multiple rotation overflow
Bus communication error