MHT258a (Engl.)7-17
・Editing a value
After reading a para., 1 digit or sign blinks at about 1 second intervals, prompting you to change that part.
Pressing the
∧ key or ∨ key changes the value. As for the sign, pressing the ∧ key or ∨ key while the cursor is located at "H" selects a
plus sign (H and blank) or a minus sign (H and -).
If 9 is followed up by 0, the value at the immediately upper place increases by 1. Or, if 0 is followed down by 9, the value at the
immediately upper place decreases by 1.
Example / 9 is followed up by 0 to give 2900
Note that there is no borrow nor carry from H side to L side or reversely.
The shifting order is as follows.
(2) (3) (1) (4) (5)
(1) Reading a para. allows to change the LSD of H side.
(2) Shifting allows to change the sign.
(3) Shifting locates the cursor to the MSD of H side. Shifting repeatedly goes to the right and then sequentially circulates within the display
range of H side.
(4) To jump from the H side to the L side, press the MODE key holding down the SHIFT key. On the L side, the MSD can be changed first.
(5) Each press of the shift key moves the cursor to the right. The LSD is followed by the MSD within the L side.
・Storing the value
Holding down the ENT key for at least 1 second stores the value, blinking all digits simultaneously 3 times. The stored value remains
displayed.
Pressing the ESC key resumes the para. selecting screen.
・Value beyond specified range
A value can be inputted within the range from minimum to maximum specified for each para.
A value beyond the specified range cannot be inputted.
LSD : Least Significant Digit
To Next Page
Loading...