7-18 MHT258a (Engl.)
・Example of editing
Let us change the setting of basic para.02 “Manual feed speed 2” to 1.0.
Keying Indication Remarks
The feedback speed monitor is displayed.
MODE
MODEMODE
MODE
ESC
ESCESC
ESC
Resumes the mode selection.
MODE
MODEMODE
MODE
ESC
ESCESC
ESC
Press the MODE key for selecting the para. edit mode.
SHIFT
SHIFTSHIFT
SHIFT
ENT
ENTENT
ENT
1 [sec] min.
Hold down the ENT key for at least 1 [sec] for designating the para.
number.
Select the basic para. 2.
SHIFT
SHIFTSHIFT
SHIFT
ENT
ENTENT
ENT
Blink
Pressing the ENT key reads the setting contents.
The LSD blinks. (Two MSDs of initial value 500.00 are displayed.)
Decrease the value to 0.
SHIFT
SHIFTSHIFT
SHIFT
ENT
ENTENT
ENT
Press the MODE key holding down the SHIFT key to display the L side
(low order 4 digits).
SHIFT
SHIFTSHIFT
SHIFT
ENT
ENTENT
ENT
Press the SHIFT key to shift the cursor to the adjacent digit on the right.
Set the value to 1. Likewise, change the LSD to 0.
SHIFT
SHIFTSHIFT
SHIFT
ENT
ENTENT
ENT
1 [sec] min.
Hold down the ENT key for at least 1 [sec] to store the new value.
Storing the value keeps it displayed. Pressing the ESC key resumes
the para. number selecting screen.
MODE
MODEMODE
MODE
ESC
ESCESC
ESC
Blink
Blink
Blink
To Next Page
Loading...