MHT258a (Engl.)2-9
(3) Slim type motor (0.05 to 0.2 [kW]) for 100 [V] class input voltage of amplifier
(a) Basic design
Type GYS□□□DC1-S 500 101 201
Rated output [kW] 0.05 0.1 0.2
Rated torque (*4) [N•m] 0.159 0.318 0.637
Rated 3000Speed [r/min]
Max. 5000
Breakdown (max.) torque (*3) [N•m] 0.478 0.955 1.91/2.87
Moment of inertia of motor rotor (×10
-3
) J[kg•m
2
] 0.00341 0.00517 0.0137
Rated 0.85 1.5 2.7Current [A]
Max. (*3) 2.55 4.5 8.1/12.1
Winding insulation class B
Operation duty type Continuous
Degree of enclosure protection Totally enclosed, IP55 except for shaft sealing
Motor power
Electrical connection
terminals
Encoder detector
With 0.3 m flexible leads and connectors
Temp. detection Without providing
Type of construction (mounting) IMB5, IMV1, IMV3, flange-mounted
Shaft extension Cylindrical extension with key
Final color for external non-machined surface Munsell N1.5
Encoder detector 16-bit serial encoder
Vibration level, peak to peak amplitude 5 micrometers
Install location For indoors, 1000[m] and below of site-altitude
Ambient climatic conditions Temperature : −10 to +40 [°C], humidity : 90 [%] RH max. (free from condensation)
Acceleration vibration, acceptable (max.) 4.9 [m/s
2
]
Mass (weight) [kg] 0.45 0.55 1.2
(*1) 15 micrometers for over the rated speed.
(*2) Direction of gear-output-shaft rotation is CCW (counter-clockwise), when motor shaft rotates forward(*).
The direction is viewed from a point facing the drive-end of motor.
(*3) Breakdown (max.) torque and maximum current values are selected in accordance with the following paired combination of amplifier
and motor types.
Lower value/higher value：
When the same output [kW] rating of amplifier and motor/when amplifier size is one step larger than the motor frame No. size
corresponding with amplifier.
Refer to 2.3.
(*4) Rated torque are continuous operating torque , on condition that motors are mounted heat sink which size are bellow table.
Motor type Heat sink size [mm]
GYS500DC1-S8 200 × 200 × 6
GYS101DC1-S6 200 × 200 × 6
GYS201DC1-S6 250 × 250 × 6
To Next Page
Loading...