4 Machine Status
118
Machine Status
4
5 Enter [New Value] with the numeric keypad.
6 Select [Save].
Store/Delete Programming
For ESC/P-K and HP-GL/2 emulations, you can register settings in memory.
You can register up to 20 print modes for ESC/P-K and HP-GL/2 emulations.
1 Select [Store/Delete Programming].
2 Select [Store Current Selections] or [Delete].
îš„ Store Current Selections
Stores the current selections. If you select a
number already used, its settings will be
overwritten with the new settings. The
overwritten settings cannot be restored.
îš„ Delete
Deletes the selected number.
Important • Deleted numbers cannot be restored.
3 Select the memory number to store or to delete.
Default Programming
You can start the machine using the settings stored in memory as default settings.
1 Select [Default Programming].
2 Select [Factory Defaults] or [Custom Settings].
îš„ Factory Defaults
You can use the factory default settings.
îš„ Custom Settings
Displays the numbers stored in memory.
3 When you select [Custom Settings], select a
memory number to use.
4 Select [Save].
Password
For PDF Direct Print, if a password is set for files, set the password here in advance. PDF files
can only be printed when the passwords assigned and entered are the same.
You can use up to 32 characters for the password.
1 Press [Password].
To Next Page
Loading...
Need help?
General
