7 Printer Environment Settings
330
Printer Environment Settings
7
address. The configuration of an IP address, a subnet mask, and a gateway address is not
required.
For information on how to set an IP address, refer to "Protocol Settings" (P.201).
4 Select [Close] repeatedly until the [Tools] screen is displayed.
5 Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message displayed on
the screen, follow the message and reboot the machine.
6 Print a configuration report to confirm that the SMB port is enabled and that TCP/IP is set
up correctly.
For information on how to print a configuration report, refer to "Print Reports" (P.106).
Note • If NetBEUI protocol is used as the transport protocol, select [NetBEUI] on the [Port Settings] screen
for SMB in CentreWare Internet Services.
7 Configure the other SMB settings as necessary.
For information on the SMB settings, refer to "CentreWare Internet Services Setting Items" (P.328).
Step 3 Configuration on the Computer
To print from the machine, you need to install a print driver on your computer.
For information on the supported operating systems, refer to "Supported Operating Systems" (P.320).
For information on the driver installation procedures, refer to the manual contained in the Driver CD Kit.
CentreWare Internet Services Setting Items
You can configure the following setting items using CentreWare Internet Services:
For details on the setting items, click [Help] at the upper right corner of the CentreWare Internet Services screen to see help.
Important • To display the online help for CentreWare Internet Services, users need to have the environment to
connect to the internet. The communication fee shall be borne by you.
For information on how to start CentreWare Internet Services, refer to "Starting CentreWare Internet Services" (P.312).
z
Spool Destination for Jobs
([Properties] > [General Setup] > [Memory Settings] > [SMB])
z
Port Settings
z
Transport Protocol
z
Maximum Connections
z
Workgroup
z
Server Name
z
TBCP Filter
Note • The TBCP filter can be configured when the Adobe PostScript 3 Kit (optional) is installed.
z
Unicode Support
z
Auto Master Mode
z
Password Encryption
z
Obtain WINS Server Address Automatically
z
Primary Server IP Address & Port
z
Secondary Server IP Address & Port
To Next Page
Loading...
Need help?
General
